TIGER T8 SW NEEDE FOR AUTO ROLL PVU

Post by **Nishan** » 27 Oct 2017, 10:34 pm

Dear friends..

I updated ver 2.75 for my Tiger T8, but tho SW gives freezing issue for cccam.

I need to downgrade any below SW but it should have PVU auto roll. Pls advise tge link to download

Post by **FARRUKH** » 28 Oct 2017, 10:47 pm

with forever u will find cccam freezing on all softwares. no software fixed with cccam. use mgcam lines. work gud on it.

Post by **maxy1** » 29 Oct 2017, 12:03 am

yep mgcamd videocon working great..

Post by **engr_shahid52** » 30 Oct 2017, 4:05 pm

FARRUKH wrote: 28 Oct 2017, 10:47 pm with forever u will find cccam freezing on all softwares. no software fixed with cccam. use mgcam lines. work gud on it.

Mgcam and C-line are same ?
how i can set mgcam to my tiger t6?

Post by **FARRUKH** » 30 Oct 2017, 4:10 pm

engr_shahid52 wrote: 30 Oct 2017, 4:05 pm
FARRUKH wrote: 28 Oct 2017, 10:47 pm with forever u will find cccam freezing on all softwares. no software fixed with cccam. use mgcam lines. work gud on it.
Mgcam and C-line are same ?
how i can set mgcam to my tiger t6?

yes both cline but different emu. you will find this option where u add cline. type is cccam or newcam/mgcam.

Golden Multimedia Forum