Missing horizontal tps on ku lnb

[zain420]

I am using single solution lnb on asiasat 7and 2 single lnb on paksat and intelsat 20.

[chazer]

I am using single solution lnb on asiasat 7and 2 single lnb on paksat and intelsat 20.

That's it , you see S.S LNB doesn't use 13V ~ 18V difference for switching between V and H Tps but KU lnb does. That's why you get both H & V on C band. You must try KU LNB with a small length of cable to confirm weather it's due to long cable or faulty receiver.

[zain420]

I have another long cable but unable to receive H tps..

[zain420]

What should i do now what are the setting of single solution lnb and how my ku lnb work properly???

[chazer]

What should i do now what are the setting of single solution lnb and how my ku lnb work properly???

There is no special setting for S.S C band LNB in the LNB power menu, you can set it to 18V, beside you've already said that C band is working properly and for KU LNB , there are some measures you can take like,1 Use high quality low loss cable , 2 use powered multi switch in between the cable. By the way how long is the cable you used and you did't share the results with small cable ???

[tiger]

Yes i am using two receiver what should i do now please help...

then you will be able to get single polarity on both receiver H or V

Solution:

You need to get a LNB with at least 2 Pin for both receivers

[chazer]

Yes i am using two receiver what should i do now please help...

then you will be able to get single polarity on both receiver H or V

Solution:

You need to get a LNB with at least 2 Pin for both receivers

He mentioned previously about the dual KU LNBs.

[chazer]

I am using single solution lnb on asiasat 7and 2 single lnb on paksat and intelsat 20.

If i understand correctly you are using Three S.S C band and two KU band LNBs, Now again the question is how all these are connected to two receivers , a detailed answer can be very helpful also how long is the cable.

[zain420]

Only one S S c band lnb and two non S S c band lnb(sadi wali ) and two ku lnb which has two output.
Two diseq switch one is of 8 in 1 and second is 4 in 1
And one powerpass 2 output wala
In first diseq(8 in 1) i have connected 1 S S and
one non S S( sadi lnb) and two ku lnb
Second diseq(4 in1) 1 s s lnb and 1 non s s lnb (sadi lnb)


I am using focus lnb single solution

[chazer]

Only one S S c band lnb and two non S S c band lnb(sadi wali ) and two ku lnb which has two output.
Two diseq switch one is of 8 in 1 and second is 4 in 1
And one powerpass 2 output wala
In first diseq(8 in 1) i have connected 1 S S and
one non S S( sadi lnb) and two ku lnb
Second diseq(4 in1) 1 s s lnb and 1 non s s lnb (sadi lnb)


I am using focus lnb single solution

Don't use power pass or any splitter in this setup, these will cause trouble and share the result. Later i'll tell you how to share LNB with multiple receivers and what is the approx cable length.