The formula how to calculate supporting rods' length

[Masood]

road kitne inch k hun ge

roads 2 meeloon (miles)mei hotay hein ,,,inch ka road bananay ka faida

[engineerkhan15]

Brother, see here the formula for calculation of rod length. For your dish type, the formula on page 2 (in the image) will be appropriate.

[engineerkhan15]

Realized now, there was an error in the second formula. Will re-post after correction.

[Masood]

any one having 8 feet shabbir dish may tell me the exact length of rods by measuring practically

[Aliraza63]

any one having 8 feet shabbir dish may tell me the exact length of rods by measuring practically

Ek shabir ki dish mere pass bhi hai main us ke measurement send kar don ga

[chazer]

Cut a wooden stick of the focal length size and hold it vertically at the center of the dish, then measure the distance from the top to where the holes for the rods. thats it

[chazer]

I forgot about screw holes, for that add about 3 inches to the measured length. Bend the rod 1.5 inch from each side for the holes. The picture explains.

[Masood]

Cut a wooden stick of the focal length size and hold it vertically at the center of the dish, then measure the distance from the top to where the holes for the rods. thats it

this is the way to measure but I need the size of supporting rods ..most probably those are 54 inches
any how thanks a lot for ur contribution kindly keep in touch in future as well.

Ek shabir ki dish mere pass bhi hai main us ke measurement send kar don ga

@Aliraza !!!
kindly make it possible in same day ....pehlay hi mei kaafi late hoon

[Masood]

just measured the length of my own dish's rods by removing and it is exactly 54 inches including holes....after bending at both ends the length decreases almost one and half inches....the depth is also less than 48 inches.
If the holes are excluded from 54 inches then depth also can be obtained 48 inches.
I can't proceed ahead till calibration is done successfully

[Aliraza63]

Cut a wooden stick of the focal length size and hold it vertically at the center of the dish, then measure the distance from the top to where the holes for the rods. thats it

this is the way to measure but I need the size of supporting rods ..most probably those are 54 inches
any how thanks a lot for ur contribution kindly keep in touch in future as well.

Ek shabir ki dish mere pass bhi hai main us ke measurement send kar don ga

@Aliraza !!!
kindly make it possible in same day ....pehlay hi mei kaafi late hoon

56 inch including holes