how to connect 1 dish 4 sats with 2 recivers??? reply must

[samidrosh123]

Doston mene
asiasat 7@105.5e
Dish tv 95e
Paksat 38e
Yahasat 52.5e sit keya howa he 4 way diseq laga howa he aur e reciver me dekhta hou
abb friends me ye 4 sat dousre kamre me bhe reciver par recive karna chahta hou
kya ye mumkin he reply must all expert is k lye kya lena pale ga???????

[awan71]

You can use loop through from your 1st receiver.

[samidrosh123]

Dost me kuch samjha nehi full detail se batawo gy plz

[Malik Bilal]

Salam

U should use twin pin lnb,s for each Sat.

[naveed_bhati]

Yes for all ku band lnbs use twin out put lnbs and for cband u can simply use splitter after lnb..

Salam

U should use twin pin lnb,s for each Sat.

[kalpikos]

Use a twin lnb for each sat you want to receiver.

The method of loop through the first receiver has many limitations.

[awan71]

twin pin lnbs goes much costly for each sat.
you may go this way use two way spliter for each satellite & connect them to an other disecq switch .
use this

Two Way spliter (all port power pass)

Picture by lumia 535

[asadq1]

did u tried at your side for each 4 LNBs ?

[awan71]

did u tried at your side for each 4 LNBs ?

Yes I am using on both c band & ku band lnbs.

[kalpikos]

Dear @awan71

Are you using this type of connection on your system?
if yes, how is your signal strength?

I'm asking you because generally, a spliter is not the recommended way for this type of connection.

Could you please give me the full characteristics of this spliter?