SPARK ka masal

[asghar101]

all SPARK



Board: STx7105-PDK [32-bit mode]


U-Boot 1.3.1 (Jun 19 2012 - 17:10:44) - stm23_0051 - YW_1.1.005 overclock

DRAM: 256 MiB
Panel: VFD
NAND: Bad block table found at page 262080, version 0x01
Bad block table found at page 262016, version 0x01
512 MiB
SPI: info: found S25FL016K (2MiB) device (page=256,erase=65536)
warning: SPI device may be write-protected (status=0x9c)
In: serial
Out: serial
Err: serial
Ident ic exist
Ident ic get stb id
IdentID : 0c 00 05 00 00 15 d0
Hit ESC to stop autoboot: 3
PDK7105> set load _addr 0*80000000
PDK7105> save
Saving Environment to SPI Serial Flash...
..
PDK7105>

Board: STx7105-PDK [32-bit mode]


U-Boot 1.3.1 (Jun 19 2012 - 17:10:44) - stm23_0051 - YW_1.1.005 overclock

DRAM: 256 MiB
Panel: VFD
NAND: Bad block table found at page 262080, version 0x01
Bad block table found at page 262016, version 0x01
512 MiB
SPI: info: found S25FL016K (2MiB) device (page=256,erase=65536)
warning: SPI device may be write-protected (status=0x9c)
In: serial
Out: serial
Err: serial
Ident ic exist
Ident ic get stb id
IdentID : 0c 00 05 00 00 15 d0
Hit ESC to stop autoboot: 3
Force command mode:Select boot (current boot system : spark):
1. spark(up key)
2. enigma2(down key)
3. RS232 Upgrade u-boot(left key)
4. Force into factory mode(right key)
Input Select:
Force Factory mode
(Re)start USB...
USB: scanning bus for devices... 1 USB Device(s) found
scanning bus for storage devices... 0 Storage Device(s) found
** Can't read from device 0 **

** Unable to use usb 0:1 for fatload **

Warning: MAC addresses don't match:
HW MAC address: FF:FF:FF:FF:FF:FF
"ethaddr" value: 00:80:E1:12:06:38
Using MAC Address 00:80:E1:12:06:38
stmac_phy_get_addr(): id1 = 0xffff, id2 = 0xffff
found phy at addres = 2
stmac_phy_get_addr(): id1 = 0x7, id2 = 0xc0f1
STM-GMAC: PHY auto-negotiate timed out
STM-GMAC: *Warning* no link detected
TFTP from server 192.168.40.19; our IP address is 192.168.40.63
Filename 'mImage'.
Load address: 0x8c000000
Loading: T T T T T T T T T T T T T T T T T T T T
Retry count exceeded; starting again
TFTP from server 192.168.40.19; our IP address is 192.168.40.63
Filename 'mImage'.
Load address: 0x8c000000
Loading: T T T T T T T T T T T T T T T T T T T T
Retry count exceeded; starting again
TFTP from server 192.168.40.19; our IP address is 192.168.40.63
Filename 'mImage'.
Load address: 0x8c000000
Loading: T T T T T T T T T T T T T T T T T T T T
Retry count exceeded; starting again
TFTP from server 192.168.40.19; our IP address is 192.168.40.63
Filename 'mImage'.
Load address: 0x8c000000
Loading: T T T T T T T T T T T T T T T T T T T T
Retry count exceeded; starting again
TFTP from server 192.168.40.19; our IP address is 192.168.40.63
Filename 'mImage'.
Load address: 0x8c000000
Loading: T T T T T T T T T T T T T T T T T T T

Board: STx7105-PDK [32-bit mode]


U-Boot 1.3.1 (Jun 19 2012 - 17:10:44) - stm23_0051 - YW_1.1.005 overclock

DRAM: 256 MiB
Panel: VFD
NAND: Bad block table found at page 262080, version 0x01
Bad block table found at page 262016, version 0x01
512 MiB
SPI: info: found S25FL016K (2MiB) device (page=256,erase=65536)
warning: SPI device may be write-protected (status=0x9c)
In: serial
Out: serial
Err: serial
Ident ic exist
Ident ic get stb id
IdentID : 0c 00 05 00 00 15 d0
Hit ESC to stop autoboot: 3
Force command mode:Select boot (current boot system : spark):
1. spark(up key)
2. enigma2(down key)
3. RS232 Upgrade u-boot(left key)
4. Force into factory mode(right key)
Input Select:
Force rs232 upgrade u-boot, need 1048576 Bytes(1024kB)
## Ready for binary (ymodem) download to 0x80000000 at 115200 bps...
CCC