DM/VU Boxes (No ca found - no connection with dreamup issue)

[Muhammad Qaiser]

Quote

Issue..
* No ca found
* No connection with dreamup
* With the usb service port and a terminal program as Putty or Hyperterminal you're receive garbage.

This could be a hardware error.
Therefore it is wise to measure at least the L800 inductor, whether it pass.
And it's also wise to measure the two crystal pins on the print side with the dc voltages measurements, both should be the same, if not then see if replacing the crystal Y800 solves the issue.

Good luck..

M. Qaiser

[dodi2000]

Quote

Issue..
* No ca found
* No connection with dreamup
* With the usb service port and a terminal program as Putty or Hyperterminal you're receive garbage.

This could be a hardware error.
Therefore it is wise to measure at least the L800 inductor, whether it pass.
And it's also wise to measure the two crystal pins on the print side with the dc voltages measurements, both should be the same, if not then see if replacing the crystal Y800 solves the issue.

Good luck..

M. Qaiser

Ustad Simple way for this error is

[M.rashid]

very good info bro but you not send this tools your video plz send tools link

[dodi2000]

very good info bro but you not send this tools your video plz send tools link

Hazar Sir here are the tools, can use both programmes

NCF-SIM2-v2.5.rar

(5.04 MiB)

JapharFlasher.rar

(1.01 MiB)