Wiccard 1.19 Ali's Edition FOR VU+

[Aliraza63]

With C line

With Biss
[attachment=1]2.jpg[/attachment]
Image Open Pli 4

With Openatv 5.1
[attachment=0]1_0_1_507B_3E8_1_3B63167_0_0_0.jpg[/attachment]
VU+Solo2

Hope it will be enough info for u . I would request rather then asking for the proof u should also try ur self to

[kalpikos]

Thank you dear Aliraza63 for your time and for uploading these pictures.

I really appreciate your support.

It's more than clear that I have problem with my installation, but I don't know what to do in order to fix it.

I use a rather new image, openpli4 (15/11/2015).

I changed the skin and I tried 3 diferent skins: openpliFullHD openpliHD, openpliHD1 but the result was the same... there is no ecm info although the wicardd seems to work properly.

[chowdary]

i think u can use hd glass 16 skin vu+

[kalpikos]

i think u can use hd glass 16 skin vu+

As I wrote above, I tested 4 different skins which are working fine with other cams (cccam, mgcamd, oscam)

I'm sure that it's not a skin problem.

Probably the version of wicardd that I use has a bug.

Tomorrow, I will test another version that I found on the net and I will post what is happened.

[kalpikos]

I tested this version of wicardd

openPLI4 + OpenPLI3 + OpenXTA + Domica10&11 + satdreamgr

Cam-Wicardd-OpenPLI_1.19-RAED.rar

(364.78 KiB)

but it has the same behavior on my box...

all are working fine except the ecm info

I also check these lines in conf file:

Code: Select all

[dvb]
active = 1
type = DVBAPI3
ecm_info = 2
sdt = 1
auto_update = 1
filter = dvb,bloker
debug = 1
emm_filter_mode = 1

but they seem to be correct.

[Rizwan Awan]

Why I am not able to Install wicardd on my Solo2 . even trying manually by DCC ?

[Aliraza63]

Why I am not able to Install wicardd on my Solo2 . even trying manually by DCC ?

Update opkg then restart and try again

[Rizwan Awan]

Installed successfully on OpenSpa, but, no better Luck on OpenPli

[Rizwan Awan]

Now its done with other DCC application and after update packages, Now Wicardd Install in Openpli

[kalpikos]

Update!!!

I finally found the solution

It was so simple !!!

The problem was in the lines I posted above

I changed the value in ecm_info = 2 to 1 and all done!!!

So, the correct lines must be:

[dvb]
active = 1
type = DVBAPI3
ecm_info = 1
sdt = 1
auto_update = 1
filter = dvb,bloker
debug = 1
emm_filter_mode = 1

Now all working fine:)

Thanks all of you for the support and especially dear Aliraza63.