@ Ghulam Jaffar: SW V. 2.10 & G-Share Co.server

[fundom]

Dear brother, mera Hyper STB "16" series se hai. Iss waqt main SW V.2.03 par hoon. Kiya upgrade to SW V.2.10 company G-Share server enable karta hai?
THX

[Dr.Timor]

Dear brother, mera Hyper STB "16" series se hai. Iss waqt main SW V.2.03 par hoon. Kiya upgrade to SW V.2.10 company G-Share server enable karta hai?
THX

Yes after injecting V.2.10 Factury Defualt is mandatory .

[Umair Malik]

Gshare Chala Bhi Gaya Toh

40 No. Server Par Ja Kar F1 press kar ke server default kar lena

[bala240]

Dear Umair any improvement on Tandberg front with the new software? The other problem I am facing is I cannot duplicate the motor positions of Vu Uno 4k on Hyper 2000. I want to use the same stored positions of satellites on both receivers. Regards

[Umair Malik]

Dear Umair any improvement on Tandberg front with the new software? The other problem I am facing is I cannot duplicate the motor positions of Vu Uno 4k on Hyper 2000. I want to use the same stored positions of satellites on both receivers. Regards

1) I havent tried v2.10 yet when I will do I will pm you the results of tandberg on it

2) I have no idea on your second question as I never used this method to store the position for motoized dish.

[kashif s]

Dear Umair any improvement on Tandberg front with the new software? The other problem I am facing is I cannot duplicate the motor positions of Vu Uno 4k on Hyper 2000. I want to use the same stored positions of satellites on both receivers. Regards

ap k pas kon a posationer hai jis pr ap stored krna chty hain

[fundom]

I thank Dr. Taimor & brother UMAIR for kind info & help.

[bala240]

Dear Kashif no problem in storing. The only issue is with Hyper where you cannot choose your storage number for satellites. You have to follow the satellite motor positions pre-stored in the Hyper 2000.

[Ghulam Jaffar]

Dear brother, mera Hyper STB "16" series se hai. Iss waqt main SW V.2.03 par hoon. Kiya upgrade to SW V.2.10 company G-Share server enable karta hai?
THX

bhai ap jo mrzi software krty rahen server ko kchh ni hota..gshare server ka concern serial nmber se hota hai..
jo k change ni hota kbhe bhe . serial nmber motherboard ka hota hai aur processor ka..
flash chip ya software se koi tauluq ni..

[fundom]

Thank you brother Jaffar for info. & guidance. BTW I have a tools, jo claim kartay hain ke serial number change kiya ja sakta hai (see attachment). Never risked trying these