Videocon on MECOOL KIII Pro

Post by **ravikakkar** » 20 Sep 2018, 10:19 pm

Right now I am on latest malay rom, so can I install it update app

Post by **engineerkhan15** » 20 Sep 2018, 10:21 pm

Yes, I think so.

Post by **engineerkhan15** » 20 Sep 2018, 10:23 pm

ravikakkar wrote: ↑20 Sep 2018, 10:16 pm Well I try easier method also it open d2h channel but they are freezing after every 3 4 second.

On stock rom it will work better.

Post by **ravikakkar** » 20 Sep 2018, 10:23 pm

Ok thanks , and any solution for d2h freezing

Post by **engineerkhan15** » 20 Sep 2018, 10:26 pm

ravikakkar wrote: ↑20 Sep 2018, 10:23 pm Ok thanks , and any solution for d2h freezing

Stock rom works better than Malaysk rom for easy method.

Post by **jessika** » 20 Sep 2018, 11:00 pm

engineerkhan15 wrote: ↑20 Sep 2018, 10:26 pm
ravikakkar wrote: ↑20 Sep 2018, 10:23 pm Ok thanks , and any solution for d2h freezing
Stock rom works better than Malaysk rom for easy method.

Stock ROM means. I have not d2h cccam. How to get

Post by **engineerkhan15** » 20 Sep 2018, 11:26 pm

Stock rom means original rom.

Post by **OmMeE** » 20 Sep 2018, 11:52 pm

engineerkhan15 wrote: ↑20 Sep 2018, 11:26 pm Stock rom means original rom.

The Original ROM does not have DVB-t2. Can we add that in the stock DTV app?

Post by **OmMeE** » 21 Sep 2018, 1:25 am

ravikakkar wrote: ↑20 Sep 2018, 10:16 pm Well I try easier method also it open d2h channel but they are freezing after every 3 4 second.

If you try to update the rom. Please do let us know if it works or not.

Thank you.

Post by **OmMeE** » 21 Sep 2018, 7:39 am

engineerkhan15 wrote: ↑20 Sep 2018, 12:16 pm One easier method is that you enable "Skip CWs checksum test" setting in "Cam Reader Config" (by the way, this is applicable for oscam on all receivers, if you want to watch videocon using oscam).
To do this follow these steps:
1. Start DTV app in android.
2. Access "Cam WebIF" by typing following command in any internet browser on PC or laptop (your Mecool box and PC should be connected to the same network for this):
BOXIP:8888
3. When WebIF opens, click on "Reader" tab at the top.
4. On next page click on "cam1" under "Reader" column to open Reader config page.
5. Scroll down to the middle of the page where you will see "Skip CWs checksum test" checkbox. If it is unchecked, check this (place a tick mark by clicking on the box".
6. Go to the bottom of this page and click on "Save" button to save this change.
7. Exit DTV app and restart again to restart the cam, after a couple of seconds the channels will start opening.
To have more clarity see following screenshot.
OSCam r11390_f1e68 (Readerconfig)_Page_1a.jpg

Thank you so much brother... This easy method works absolutely perfect!!!

JazakAllah..

Golden Multimedia Forum